Standard System Features - Inverter Series |
| 1 Filter housing completely assembled with 1 hose barb outlet (1/2" with boost pump or 5/8" without boost pump) |
| 1 316 Bracket with 8 screws |
| 2 20 micron pre-filter cartridges |
| 1 Intake 3-way valve with 2 hose barb fittings (Service:5/8", Intake: 1/2" with or without boost pump) |
| 1 Titanium reinforced stainless steel high pressure pump with high efficiency electric motor competely assembled |
| 1 40" Pressure vesselswith reverse osmosis membranes (model 260) or |
| 2 40" Pressure vessels with reverse osmosis membranes (model 380) |
| 1 316 Stainless steel control panel completely assembled with |
| 1 Automatic pressure regulator valve |
| 1 High pressure gauge |
| 1 Product flow meter |
| 1 Electrical switch (model 200-12V-30amps, 200-24V-20amps, 240-24V-30amps, 260/380-12V-50amps, 260/380-24V-30amps |
| 1 Diverter (3 way) valve with 3/8" compression fittings |
| 12 feet / 3.5m high pressure hose with 2 316Ti high pressure fittings attached |
| and 2 316Ti field attachable high pressure fittings Installation Materials |
| 30 feet PVC tubing for product and reject water |
| 3 Nylon fittings 1/4" NPT for 3/8" PVC tubing ( 2x tank straight or elbow and 1 reject thru hull connection straight) |
10 feet wire coil reinforced intake hose ( installation without boost pump only ) 2 feet wire coil reinforced intake hose 5/8" ( installation with boost pump) or 10 feet braided hose 1/2" ( installation with boost pump ) 1 set of 316SS hose clamps 1 Biocide, 1 acid cleaning solution, 1 alkaline cleaning solution ( each 330g ) 1 Installation and operating manual |
| Hose Connections | |
| High pressure pump intake ( without boost pump) | 5/8" / 16mm |
| High pressure pump intake (with boost pump) | 1/2" / 12mm |
| Boost pump intake | 5/8" / 16mm |
| Brine reject PVC tubing | 3/8" / 10mm |
| Product water PVC tubing | 3/8" / 10mm |